Can you make a hole in a bottle full of water but....... NOT MAKE THE LIQUID SPILL????
Materials:
A empty, clean plastic bottle with a screw on lid.
A pushpin
Water
Materials:
A empty, clean plastic bottle with a screw on lid.
A pushpin
Water
Instructions
With the push pin, poke a hole in the bottle near the bottom and leave the pushpin stuck in the bottle.
Hold your thumb against the pushpin . And fill the bottle with water till the brim, and screw on the cap.
Continue this experiment in the kitchen sink.
Remove the pushpin.
Observe: The water pours out through the hole at first and then stops!!!
What happens???
The air pressure inside the bottle was strong, but the air pressure outside the bottle was even stronger. The outside pressure caused the water to stop flowing.